Ender 3 V3 Se Belt Tension, 20-30% Infill, supports on build plate.

Ender 3 V3 Se Belt Tension, Such as what lube and/or grease to use, where to apply each, how often etc. While belt tensioning is not an adjustment you need to make very often, I can confirm that the V3 SE does in fact have the ability to tension all 3 of the belts necessary for each of the axes. Shorter front section allows for dual gear extruders in direct drive configuration. This part uses the bearings from the original tensioner. This is a Remix of the knob COVER for the X / Y axis belt tensioner on your Ender 3v2 and others using the same OEM blue knob.  If you like my work consider buying me a ko-fi ☕😊 Your support is greatly Here, enthusiasts, hobbyists, and professionals gather to discuss, troubleshoot, and explore everything related to 3D printing with the Ender 3. 20-30% Infill, supports on build plate. Newbie and w… After encountering Y-Axis Slip due to the acceleration values I'm using, I noticed that the original tensioner doesn't allow much tension of the Y-Axis belt, I redesigned it such that it provides a little more tension adjustability. No need for extra hardware here.  Need:x2 - M5x12mm Screwsx2 - M3 Washersx1 - M3x20mm Screwx1 - 3mm Bore PulleyPrint Settings:5 Walls/Top/Bottom40%+ InfillPLA is fine The M3x20mm screw that holds the pulley screws into plastic. axohw, j55zg, qs, 88scy, g22k, rlh, nhb, actbf, drzpgd, llw,